LoadGuard - Hoist Components

Brake

New advanced brake design

Steel brake discs, guided by internal and external guidance fins, reduce brake wear and resetting requirements. Virtually maintenance free

Maximum safety- the brake is mounted after the slipping clutch, clutch wear will not affect the integrity of the load

Double brake assembly available; these can be independently checked for correct operation

Simple technology (no electronics susceptible to interference)

Reliable construction using proven components

Emergency stop with contactor available if required (sometimes needed in permanent installations)

42V control system allowing highest safety of operation, (110V or 24V available on request)

Available with 2 or 4 position limit stops

Simple adjustment, with positioning and repeatability

Lifting heights up to 120 m (3 drive ratios are possible)

Improvements to gear designs reduce noise levels

Helical first and second gear teeth for quieter running

Permanent grease lubrication for wear resistant operation, no oil leaks

Manufactured from hardened steel

With additional chain pockets, type 25 hoist with 6 pockets, other hoists have 5 pocket load chain wheel- quiet with improved running properties

Double bearing support, sealed bearings available on request

Replacement can be carried out without stripping the hoist

2-part construction to optimize maintenance

Reinforced glass fibre / plastic material is highly wear resistant

Wear plate fitted to underside of hoist to aid chain guidance and eliminate chain jamming

Simple and precise adjustment at workshop level, no exterior adjustment

Clutch is located in the rotor shaft, outside the drive train; clutch wear will not affect the integrity of the load

Maintenance free and highly resistant to wear

Clutch parts available if required - no need to buy complete assemblies

Ease of servicing thanks to comfortable access

Designed for tough working conditions

Single or 2 speeds available in a variety of speeds, normal, fast and super fast to suit your application

Special power supplies available including some hoists for single phase power supplies

Options- with thermal cutout device to prevent overheating and anti phase system to prevent mis-phasing

Calibrated especially for the hoist

Black coated as standard or Zinc plated if required

Surface case hardened quality class DAT (8SS) to FEM 9.671

Cast aluminum housing with maximum solidity

For extreme working conditions: the body has cast cooling fins to dissipate heat caused by operation

Easy change from 1-fall to 2-fall operation: no need to dismantle the hoist

Latest Aluminium casting technology used- manufactured by an automotive industry supplier

Aluminium end covers fitted- sealed to prevent water penetration